Product Description
Engraved ERay Access Covers for the C8 Corvette Engine Bay
C8RallyDriver ERay Access Covers replace the stamped steel factory access covers on the B-pillars of every 2020+ C8 Corvette coupe. Each cover is CNC machined from 6061 billet aluminum, anodized in black, red or blue, and engraved with the GM Officially Licensed ERay logo. They are one of the most visible upgrades in the C8 engine bay and the finishing touch for car shows and events.
The covers are a direct bolt-on replacement. No modification to the car, no drilling, and installation takes under 10 minutes with the factory T15 screws. Add one of our C8RD Titanium Fastener Kits to match or contrast the anodized finish, and pair the covers with the RaceLite Hatch Supports, which come in the same anodized colors.
Choose your logo
Shop by your model and pick the logo you want on the car. The engraved covers are also available in Corvette Flags, C8.R, Z51, Z06, 70th Anniversary, ZR1, Stingray. Prefer a factory paint match with a 3M vinyl logo instead of an engraved anodized finish? See the C8 Corvette Access Covers in all factory colors.
Included
Boxed presentation set of two C8 Corvette ERay Access Covers with new foam seals pre-attached, in a black presentation box. A ready-made gift for any C8 owner.
Fitment
Fits all 2020+ C8 Corvette coupes: Stingray, Z51, Z06, ERay, ZR1, ZR1X, Grand Sport and Grand Sport X. Does not fit the Hard Top Convertible, which has no factory access covers. HTC owners: see the C8 Corvette HTC Fast Access Covers.
Anodized Finish
While we use the highest quality dyes and anodizing processes, all anodized parts are susceptible to color fade from exposure to UV light, heat and cleaners. To maintain the vibrant color of your anodized parts as long as possible, minimize long term sunlight exposure with garage storage, car covers and coating the products with a UV inhibiting SiO2 and graphene ceramic spray coating after washing and on a regular detailing cycle. This will also help keep the product clean and avoid mineral deposits and water spots. Do not use chemical or acid based cleaners on anodized parts.
Installation
Cover the drain hole below each access cover with tape so the factory T15 screws cannot drop through. Remove the stamped metal factory covers and clean the B-pillar. Fit one nylon washer on each factory screw or titanium fastener to protect the new finish, then seat the C8RD covers and hand-tighten the fasteners, alternating top to bottom, until the cover sits straight. A fastener should turn with little to no resistance; if it binds, back it out and re-seat it rather than forcing it, or the threaded insert can be damaged. Do not overtighten. Install videos are on our installation guides page.
Browse all C8RD Billet Machined Parts.
